Download MODEL XL-21

XL-21
LCD DISPLAY PROGRAMMING
M O D E S O F O P E R AT I O N
The LCD display may be operated in three different modes:
Operating Mode
Programming Mode
Test Mode
This mode includes:
“Full Cycle”
“Step Move”
“Move Table Only”
“Repair Cycle”
When the display is set to Full Cycle, the machine is ready to automatically sew a complete buttonhole. Toe
the start treadle to begin the sewing cycle and the table motor will move the table from the home position to
the sew position.
Note: Sewing speed may be adjusted up to 1,850 spm.
In the sew position, the table motor stops, the sew motor starts, and the following options may be selected:
1) Slow start
2) Slow end
To overlap the last stitch with the first stitch, use the adjustable stitch counter.
The table motor starts again and moves the table back to the home position. While moving to home,
the hole is punched. Once the hole is punched, the clamps may be raised before the table reaches the
home position.
The Single Step mode provides the option of stepping through each operation for easy adjustments
and maintenance. To access:
Toe the Start treadle and the table moves to the sew position.
Toe the Start treadle again to sew the buttonhole.
Toe the Start treadle a third time and the table moves back to the home position, after punching the hole and
lifting the clamps.
The Move Table Only mode, primarily for adjusting the buttonhole puncher, moves the table only
from home to home position.
1-20
Revised 02/2003
e-mail: [email protected]; [email protected]; website: www.amfreece.com
Phones: +420 582 306 160 (Service), +420 582 309 189 (343) (Spare Parts); Fax: +420 582 360 606