Download Warning

Kodak 8800 Multi-Input Manager Service Manual
Section 2 – Installation
1999 Rev. F
Setting the Single/Dual Transfer Jumper
1. For 9-bit modules: Check that the Single/Dual
jumper is in the Single position (shorted across
W9-2 and W9-3). This is the factory setting.
2-13
Jumper
Pins
User Control Input
Fiber Optics
Image Data Input
Fiber Optics
COMM 1
COMM 2
2. For 12-bit modules:
a. If the image source is video or 8- or 9-bit
digital, check that the Single/Dual jumper is
in the Single position (shorted across W9-2
and W9-3). This is the factory setting.
b. If the image source is 10-, 11- or 12-bit
digital, set the Single/Dual jumper to the Dual
position (shorted across W9-1 and W9-2).
W9–1
W9–2
W9–3
32 MP Memory
Expansion Board
(On 64–MP
Versions Only)
8800–30L
Figure 2-12. New Input Module