Download SERVICE MANUAL

Starting Relay Earthing Loop Inspection
Remove starting relay connector.
Inspect conductivity between wire connector
terminal yellow/red wire and motorcycle earthing.
Conductivity between terminal yellow/red
wire and motorcycle earthing when starting button
is pressed.
Inspect conductivity of starting button and
wire.
Connect starting relay with storage
battery, connect starting motor terminal with
three-in-one meter.
Connect fully charged storage battery
between yellow wire/red wire and green
wire/yellow wire.
When storage battery voltage is introduced,
conductivity between relay, storage battery, starting motor terminal should be normal.
V. LIGHTING AND SIGNAL SYSTEM SERVICE
Troubles
Burnt bulb in lighting system
Causes
Partial damage of voltage adjusting
rectifier
Inadequate charging
Flashing relay failure
Damaged direction lights switch
Circuit failure
Burnt bulb or poor contact between bulb
and bulb seat
Breakage of earthing wire
Short circuit of taillight
Inadequate storage charging
Wire failure
Horn failure
Fuel gauge failure
Damaged oil level float
All direction lights are off.
One direction light is not on and one does
not flash.
When braking, all lighting lamps and
direction lights are on but headlight
Silent horn or horn sound too low
No indication of fuel gauge
43