Download manual

Section 8
Electrical
Sensors
Kenworth’s chassis contain standard connectors in the wiring harnesses for gauges even when they were not specified
on a particular chassis. The following diagram shows the locations of standard connectors in the wiring harnesses. This
allows you to easily locate connectors to add gauges. To add an electronic gauge install the sensor (available from your
local Kenworth dealer) in the noted location, plug in the wiring harness, and then install the gauge in the dash. The gauge
will then need to be activated. Your local Kenworth dealer can easily activate the gauge using Kenworth’s Electronic Service Analyst (ESA).
Brake
Application
Sensor
FIGURE 8-7. Instrumentation Harness Interface Diagram
8-7
12/11