Download automatic transmission

Transcript
AUTOMATIC TRANSMISSION
Speedometer drive pinion (MB)
REPLACING
1st CASE:
23
Loosen the pinion with a screwdriver and recover
it.
Only the speedometer drive pinion or
shaft is damaged.
Fit the new speedometer drive pinion using a pair
of flat-nose pliers.
The automatic transmission must be removed but
the final drive assembly does not have the be dismantled. Process as follows:
From the differential, remove:
- the circlip (22) and the washer (21),
- the sunwheel (20).
The pinion and its drive shaft can be refitted by
hand. The drive shaft must be correctly positioned
in relation to the pinion key notches due to the resilience of the lips of the shaft.
Use a mallet to ensure that it is properly clipped in
place.
86528R
86053S
Pull the speedometer drive shaft using a pair of
flat-nose pliers.
Reposition the drive shaft (19) in the differential
and refit:
- the sunwheel (20),
- the washer (21) (make sure that the notch is in
the correct position) and its circlip (22).
Rotate the differential until the speedometer
drive pinion can be seen inside it.
Refit the automatic transmission
2nd CASE:
The speedometer drive pinion and
wheel are damaged.
The automatic transmission does not have to be
removed and the final drive does not have to be
dismantled.
88577S
23-39