Download automatic transmission
Transcript
AUTOMATIC TRANSMISSION Speedometer drive pinion (MB) REPLACING 1st CASE: 23 Loosen the pinion with a screwdriver and recover it. Only the speedometer drive pinion or shaft is damaged. Fit the new speedometer drive pinion using a pair of flat-nose pliers. The automatic transmission must be removed but the final drive assembly does not have the be dismantled. Process as follows: From the differential, remove: - the circlip (22) and the washer (21), - the sunwheel (20). The pinion and its drive shaft can be refitted by hand. The drive shaft must be correctly positioned in relation to the pinion key notches due to the resilience of the lips of the shaft. Use a mallet to ensure that it is properly clipped in place. 86528R 86053S Pull the speedometer drive shaft using a pair of flat-nose pliers. Reposition the drive shaft (19) in the differential and refit: - the sunwheel (20), - the washer (21) (make sure that the notch is in the correct position) and its circlip (22). Rotate the differential until the speedometer drive pinion can be seen inside it. Refit the automatic transmission 2nd CASE: The speedometer drive pinion and wheel are damaged. The automatic transmission does not have to be removed and the final drive does not have to be dismantled. 88577S 23-39