Download Section 3 - Neopost Technologies Ltd

100/140 Service Manual
Page 3 - 30
Issue 10 Mar 2011
3.16 FITTING AN OMR HEAD
3.16.1
Machines not fitted with OMR can be upgraded to full OMR specification by ordering the appropriate kit of parts:
Fig. 22 below shows the assembly of the parts prior to fitting to the machine. If not already built when received, assemble parts now (Tower OMR
Bar C9382A with head/foot assembly fits into the Tower Access assembly,
as described later). Note that top read is shown - if bottom read is required,
swap over the positions of the OMR head and foot assembly opposite. The
location along the bar of the OMR head depends upon the required approximate position to align with the marks on the paper. Wherever it is located,
the sliders C6223A should be roughly evenly distributed about it.
A3247A
3-Tray 3P Folder, OMR on Station 1 only
A3248A
3-Tray 3P Folder, OMR on Stations 1 & 2 (cascade)
A3266A
Single Tray 3P Folder
Also available is A3261A, OMR Head & Foot Kit. This comprises the OMR
head together with the aluminium foot with spring-loaded nylon shoe. The
full upgrade kits also include all brackets, sliders and slider bars.
3-Tray 3P Folder, OMR on station 1 only (Kit A3247A)
cont.
S1
Fig. 22
Page 3 - 30
Page 3 - 30