Download SERVICE MANUAL

ELECTRICAL SYSTEM
2.5.5 Removing front bearing
Remove the screw, and then remove the bearing retainer and
front bearing from the front bracket.
Front bracket
Front bearing
Removing front bearing
2.5.6
Removing stator
CAUTION
Unsoldering must be finished as quickly as possible.
Extended heating will damage the diodes.
Stator
Lead wire
Rectifier
Unsolder the joint of the stator and remove the stator from
the rectifier.
Removing stator
2.5.7 Removing regulator assembly
Remove the screws of the regulator assembly and then
remove the regulator assembly.
Rear bracket
Rectifier
Regulator assembly
Removing regulator assembly and rectifier assembly
2.5.8
Removing rectifier assembly
(1) Remove the screw and nut from the rectifier.
(2) Remove the rectifier assembly.
12-19