Download TKR-850 REVISED

TKR-850
GENERAL / SYSTEM SET-UP
INTRODUCTION
PERSONNEL SAFETY
SCOPE OF THIS MANUAL
This manual is intended for use by experienced technicians familiar with similar types of commercial grade communications equipment. It contains all required service information for the equipment and is current as of this publication date. Changes which may occur after publication are
covered by either Service Bulletins or Manual Revisions,
which are issued as required.
The following precautions are recommended for personnel safety :
• DO NOT transmit until all RF connectors are secure and
any open connectors are properly terminated.
• SHUT OFF this equipment when near electrical blasting
caps or while in an explosive atmosphere.
• This equipment should be serviced by only qualified technicians.
ORDERING REPLACEMENT PARTS
SERVICE
When ordering replacement parts or equipment information, the full part identification number should be included.
This applies to all parts : components, kits, and chassis. If
the part number is not known, include the chassis or kit
number of which it is a part and a sufficient description of
the required component, for proper identification.
This radio is designed for easy servicing. Refer to the
schematic diagrams, printed circuit board views, and alignment procedures contained in this manual.
SYSTEM SET-UP
Frequency range (MHz)
TX/RX 450~480
TX/RX 480~512
TX/RX 400~430
TX/RX 440~470
Merchandise
received
Choose the type
of transceiver
RF power
40W
40W
40W
40W
Type
K
K2
K3
E
See page 11.
Repeater
A personal computer (IBM PC or compatible), programming interface (KPG-46),
programming & setup
and programming software (KPG-66D) are required for programming.
DC power
supply or
duplexer?
YES
Installation in the
optional space
NO
External speaker?
NO
Delivery
2
YES
KES-4 installation