Download SERVICE MANUAL

5.
Fault diagnosis
5.1
What to do if ...?
Problem
The cooking zone cannot be
switched on or is not
functioning
Possible cause
More than 10 seconds have
passed since the appliance
was switched on
The child safety lock is
activated
Numerous sensor panels
were touched simultaneously
Automatic deactivation has
been triggered
There is water on the
operating panel or the
operating panel is covered
by fat splashes
Stop + Go is active
Buzzer sounds when
The operating panels
appliance is switched off
completely or partially
covered by objects.
There is water on the
operating panel or the
operating panel is covered
by fat splashes
The residual heat display
The cooking zone has only
does not display anything
been on for a short time and
is therefore not hot yet
The On/Off sensor panel has
The buzzer sounds and the
appliance switches itself on
been covered up, e.g. by a
and off again after 5 sec.; the cloth
buzzer sounds again after 5
sec.
"-" is illuminated
Automatic deactivation has
been triggered
"E“ and a number are
displayed
Electronics error
"?“ is illuminated
Automatic deactivation has
been triggered
DGS-TDS-N 12.07 U. H. / A. B. © Electrolux
- 12 -
Remedy
Switch appliance back on
Deactivate the child safety
lock (see chapter "child
safety lock")
Only touch one sensor panel
Remove any objects (pot,
cloth, etc.) from the
operating panel, switch
appliance back on
Wipe over operating panel
Deactivate Stop + Go
Gegenstände entfernen
Wipe over operating panel
Contact customer service of
the cooking zone is hot
Do not place any objects on
the operating panel
Switch cooking zone off,
switch cooking zone back on
again
Disconnect the appliance
from the mains for a few
minutes (remove the fuse
from the house fuse cabinet).
if "E" isstill displayed after
switching back on, contact
customer service
Switch cooking zone off and
then back on again
599 531 461
EN