Download AR-EF1 - Printertec

!"#$%&
[10] SIMULATIONS
1. Entering the simulation mode
Enter the copy mode and perform the following procedures.
[P]
[*]
[C]
[*]
[Main code]
[START]
[Sub code]
[START]
2. Switching the simulation mode
Press [USER SETTING] to return to the code entry screen.
3. Canceling the simulation mode
Press CA key to cancel the simulation mode.
4. Simulation list
Code
Main Sub
1
2
3
4
5
6
7
Function (Content)
Purpose
Section
Item
1
Used to check the operations of the scanner (reading) unit and Operation test, check
its control circuit.
Scanner (reading)
Operation
2
Used to check the operations of the sensors and detectors in
the scanner (reading) unit and their control circuits.
Scanner (reading)
Operation
1
Used to check the operations of the automatic document feeder Operation test, check
unit and its control circuit.
DSPF
Operation
2
Used to check the operations of the sensors and detectors in
the automatic document feeder unit and their control circuits.
Operation test, check
DSPF
Operation
3
Used to check the operation under load in the automatic
document feeder unit and their control circuits.
Operation test, check
DSPF
Operation
2
Used to check the operations of the sensors and detectors in
the finisher and their control circuits.
Operation test, check
Finisher
Operation
3
Used to check the operation under load in the finisher and their Operation test, check
control circuits.
Finisher
Operation
6
Used to adjust the stacking capacity of the finisher.
Adjustment
(Used to adjust the alignment plate (jogger) stop position in the
finisher paper width direction. The adjustment is made by
changing the alignment plate home position in the paper width
direction by software. )
Finisher
Operation
Operation
Operation test, check
10 Used to adjust the console finisher (AR-FN7).
Adjustment
Finisher
20 Used to check the mail bin stacker (AR-MS1) sensor.
Operation test, check
Mail bin stacker
Operation
21 Used to check the operations of the mail bin stacker loads.
Operation test, check
Mail bin stacker
Operation
2
Used to check the operations of the sensors and detectors in
the paper feed section (desk paper feed/large capacity trays)
and their control circuits.
Operation test, check
Paper feed
Operation
3
Used to check the operation under load in the paper feed
Operation test, check
section (desk paper feed/large capacity trays) and their control
circuits.
Paper feed
Operation
1
Used to check the operations of the lamps and LCD on the
operation panel and their control circuits.
Operation
(display, operation)
Operation
2
Used to check the operations of the heater lamp and its control Operation test, check
circuit.
Fusing
Operation
3
Used to check the operations of the copy lamp and its control
circuit.
Operation test, check
Scanner (reading)
Operation
1
Used to check the operation under load (clutches and
solenoids) in the paper transport system and their control
circuits.
Operation test, check
Paper transport
Operation
(paper exit,
switchback, transport)
2
Used to check the operations of each fan motor and its control Operation test, check
circuit.
Operation test, check
Others
Operation
1
Used to set the aging conditions.
Setup
Operation
6
Used to set the intermittent aging cycle.
Setup
Operation
8
Used to set Enable/Disable of warm-up time display.
Setup
Operation
AR-M350 SIMULATIONS 10-1