Download GENERAL INFO

Austauschen der
Replacement
ofBremsschuheinheit
the cartridge shoe
BRAKES
Loosen
the screw
Die Schraube
lösen.
2mm
key
2mm allen
Inbusschlüssel
screw
Schraube
Brake adjustment general
Your SCOTT bike is fitted with a reliable and well-functioning braking system, provided
the brakes are correctly adjusted. Check by measuring the distance between the brake
shoes and the rim: it should be 1.5 to 2 mm.
remove
the
shoe
sliding it along
groove ofaus
theder
shoe
holder
Schieben
Sie
denby
Bremsschuh
zumthe
Abnehmen
Bremsschuhhalternut.
shoe
Bremsschuh
Cable connection and adjustment of the (Dual Pivot) brake
1. Put the quick lever on the closed position.
2.Adjust the brake shoe clearance (as shown in the illustration) and secure the cable
with the pinch bolt nut.
Cable bolt tightening torque 6-8 Nm
There
two different
shoeverschiedene
and shoe holder
to be used
Auf derare
rechten
und linkentypes
Seite of
werden
Bremsschuhe
undin the left and
right
positions respectively.
Slide theSie
new
shoes
into
the grooves
on the shoe
Bremsschuhhalter
verwendet. Schieben
den
neuen
Bremsschuh
in die
holders
while taking und
note
of theSie
correct
and screw hole
positions.
Bremsschuhhalternut
achten
darauf,directions
daß die Einschubrichtung
und
die
Schraubenlöcher richtig übereinstimmen.
for
the left
für linke
Seite
same
gleich at
für front
vorneand
und rear
hinten
Zentrierschraube
centering
adjustment bolt
brake
shoe holder
Bremsschuhhalter
for
the right
für rechte
Seite
same
gleich at
fürfront
vorneand
und rear
hinten
vorne
front
vorne
front
brake
shoe
Bremsschuh
brake
shoe
Bremsschuh
Bremsschuhhalter
brake
shoe holder
open
offen
3mm
allen key
3mm-Inbusschlüssel
closed
geschlossen
A + B
screw
Schraube
quick
release lever
Schnellspannhebel
22
= 3 - 4 mm
1
2
shoe
insertion
Bremsschuhdirection
einschub-
1
richtung
screw
Schraube
tighten
the set
screw
Die Schraube
wieder
festziehen.
tightening
torque: 1-1,5 Nm
(9-13
Anzugsdrehmoment:
1 - 1,5
Nm in. lbs.)
Centring the brake shoes
Make a minor adjustment by using the centring adjustment screw.
1. Loosen up the security screw with a 2 mm allen key.
Readjustment of the brake shoe clearance
2.Push the used brake pad out of the aluminium brake shoe.
Turn the cable-adjustment bolt to readjust the brake shoe clearance.
3.Push the new brake pad into the brake shoe, and beware of the arrow which
shows the mounting direction.
GENERAL
Change of brake pads
centering adjustment bolt
8
BIKE OWNER’S MANUAL
ENGLISH
4.Tighten up the security screw to approximately 1.5 Nm.
scott-sports.com
9