Download GENERAL INFO

V-Brakes
Replacement of the brake pads/cartridge shoe
1. While holding the shoe against the rim, tighten the shoe fixing nut.
Remove the security pin on the brake shoe.
2.Pass the inner cable through the inner cable lead, and after setting so that the total
of the clearances between the left and right shoes and the rim is 2 mm tighten the
cable fixing bolt.
1. Remove the brake pad by sliding it along the groove of the brake shoe bar.
tightening torque :
Anzugsdrehmoment:
6-8 Nm (52-69 in. lbs.)
6 – 8 Nm
5mm allen key
inner cable lead
B
2.Make sure to use the correct brake pad and brake shoe for each side.
Those for the left side are different from those for the right side.
3.Slide the new pad into the shoe and make sure that the direction is correct and
that the security pin holes concord.
4.The insertion of the security fixing pin is very important. It keeps the shoe properly
in place
C
B + C = 2 mm
3. Adjust the distance with the spring tension adjustment screws.
2
1
2
Spring tension
Federeinstellschraube
adjustment
screw
1
1
1 mm
2
GENERAL
Spring tension
Federeinstellschraube
adjustment
screw
1 mm
ENGLISH
4. Depress lever about 10 times
Bremshebel circa 10
mal anziehen
10
BIKE OWNER’S MANUAL
scott-sports.com
11