Download Service Manual

Chapter 3 How to use control panel
46
Exhaust gas temperature
After ‘0:ot’ has been displayed by
Press dial button for 1 sec when
pressing ‘current status button’ for 5
secs, turn the dial until it shows ‘H:Eh’. ‘H:Eh’ shows up.
Press dial button for a sec again, to
go back to the previous mode.
Current exhaust gas temperature
status will be displayed. (ex : 130℉)
Press ‘current status button’ with
‘H:Eh’ mode to go back to the initial
status.
Internal storage tank water temperature.
After ‘0:ot’ has been displayed by
pressing ‘current status button’ for 5
secs, turn the dial until it shows ‘I:St’.
Press dial button for 1 sec when ‘I:St’
shows up.
Press dial button for a sec again, to
go back to the previous mode.
Press ‘current status button’ with ‘I:St’
mode to go back to the initial status.
LP-528 REV. 8.01.14
Current hot water tank temperature
status will be displayed. (ex : 130℉)