1
Download 2002 DEEP SNOW SERVICE MANUAL
Transcript
ENGINES Disassembly, Cont. 13. Remove impeller nut. 14. Slide shaft out back side. 15. Inspect bearings. Replace if necessary. Replace mechanical seal using the special tools listed below. Use the seal press to install a new mechanical seal in cover with spring sleeve toward impeller housing. Install seal guide over end of shaft and apply a light film of grease to seal guide. Carefully install shaft and bearings in cover. Assemble 10x14mm washer, impeller, washer, and nut. Torque impeller nut to specification. Water Pump Mechanical Seal Installation Tool - 600/700/800 RMK domestic engines: 8.9mm. PN 2872389 Impeller Nut Torque 10 ft. lbs. (14 Nm) 3.39
