Download maintenance work on chassis and engine

Transcript
MAINTENANCE WORK ON CHASSIS AND ENGINE
22
Checking the static sag of the shock absorber
9.5
A
0
–
Measure distance  of rear wheel unloaded. (
–
Ask someone to help you by holding the motorcycle upright.
–
Measure the distance between the rear axle and the fixed point again.
–
Make a note of the value as measurement .
p. 21)
Info
The static sag is the difference between measurements  and .
–
Check the static sag.
»
B
0
Static sag (50 SX)
20 mm (0.79 in)
Static sag (50 SX Junior)
20 mm (0.79 in)
Static sag (50 SX Mini)
10 mm (0.39 in)
If the static sag is less or more than the specified value:
–
Adjust the spring preload of the shock absorber.
x(
p. 22)
400221-10
Adjusting the spring preload of the shock absorber
9.6
x
Danger
Danger of accidents The shock absorber is under high pressure.
–
The shock absorber is filled with highly compressed nitrogen, so never dismantle the shock absorber or carry out any maintenance on it yourself.
–
Remove shock absorber.
–
After removing the shock absorber, clean it thoroughly.
–
Measure the full spring length while it is under tension and note down the value.
–
Loosen lock ring .
–
Turn adjusting ring  until the spring is no longer under tension.
x(
p. 23)
Combination wrench (50329080000)
Hook wrench (T106S)
–
Measure the overall spring length when not under tension.
–
Tighten the spring by turning adjusting ring  to measurement.
Requirement
700506-01
Spring preload (50 SX)
Standard
3 mm (0.12 in)
Spring preload (50 SX Junior)
Standard
5 mm (0.2 in)
Spring preload (50 SX Mini)
Standard
5 mm (0.2 in)
Info
Measure is the difference between the relaxed spring length and the tensioned spring length.
Depending on the static sag and/or the riding sag, it may be necessary to
increase or decrease the spring preload.
–
Tighten lock ring .
–
Installing shock absorber.
x(
p. 23)