1
Download maintenance work on chassis and engine
Transcript
IMPORTANT NOTES 5 Use definition KTM sport motorcycles are designed and built to withstand the normal stresses and strains of competitive use. The motorcycles comply with currently valid regulations and categories of the top international motorsport organizations. Info The motorcycle must be used only in closed off areas remote from public road traffic. Maintenance A prerequisite for perfect operation and prevention of wear is that the engine and chassis maintenance and adjustment work described in the owner's manual are properly carried out. Poor adjustment and tuning of the engine and chassis can lead to damage and breakage of components. Using the motorcycle in extreme conditions such as very muddy or wet terrain can lead to above-average wear of components such as the transmission train or the brakes. For this reason, it may be necessary to service or replace worn parts before the limit specified in the service schedule is reached. Pay careful attention to the prescribed running-in period, inspection and maintenance intervals. If you observe these exactly, you will ensure a much longer service life for your motorcycle. Warranty The work prescribed in the service schedule must be carried out in an authorized KTM workshop only and confirmed in the customer's service record, since otherwise no warranty claims will be honored. No warranty claims can be honored for damage resulting from manipulations and/or alterations to the vehicle. Fuel, oils, etc. You should use the fuels, oils and greases according to specifications as listed in the owner's manual. Spare parts, accessories For your own safety, only use spare parts and accessory products that have been approved and/or recommended by KTM and have them installed in an authorized KTM workshop. KTM accepts no liability for other products and any resulting damage or loss. The current KTM PowerParts for your vehicle can be found on the KTM website. International KTM Website: http://www.ktm.com Work rules During assembly, non-reusable parts (e.g. self-locking screws and nuts, seals, seal rings, O-rings, pins, lock washers) must be replaced by new parts. If a thread locker is used for the screw connections (e.g. Loctite®), follow the specific manufacturer instructions regarding its use. Parts that are to be reused after disassembly must be cleaned and checked for damage and wear. Change damaged or worn parts. After repair and maintenance, ensure that the vehicle is roadworthy. Transport Note Danger of damage The parked vehicle can roll away or fall over. – Always place the vehicle on a firm and even surface. Note Fire hazard Some vehicle components get very hot when the machine is driven. – Do not place the vehicle where there are flammable or explosive substances. Do not place objects over the vehicle while it is still warm from being run. Always let the vehicle cool first. – Switch off the engine. – Use straps or other suitable devices to secure the motorcycle against accidents or falling over.
