Download IRIS BLUE - Santerno

BASIC
USER MANUAL
IRIS BLUE
5.4. Warnings
Warning messages are displayed on the display/keypad. They are flashing messages that usually appear in line 1 or 2
on the display.
NOTE
Warnings are neither protections nor alarms, and are not stored to the Fault list.
Warning
Message
W03
SEARCHING…
The user interface is searching the data of the next page to display.
W04
DATA READ KO
Software warnings concerning data reading.
W06
HOME SAVED
W07
DOWNLOADING
W08
UPLOADING
W09
DOWNLOAD OK
W11
UPLOAD OK
W12
UPLOAD KO
W13
NO DOWNLOAD
W16
PLEASE WAIT…
W17
SAVE IMPOSSIBLE
W18
PARAMETERS LOST
W19
NO PARAMETERS
LOAD
W20
NOT NOW
W21
CONTROL ON
W23
DOWNLOAD VER. KO
W24
VERIFY DATA
W28
OPEN START
W32
OPEN ENABLE
W33
WRITE IMPOSSIBLE
W34
ILLEGAL DATA
W35
NO WRITE CONTROL
W36
ILLEGAL ADDRESS
Description
The page displayed has been saved as the home page displayed at power on.
The keypad is writing to the drive the WORK zone parameters saved to its own
flash memory.
The keypad is reading from the drive the WORK zone parameters that will be
saved to its own flash memory.
Parameters were successfully downloaded (written) from the keypad to the drive.
Parameters were successfully uploaded (read) from the drive to the keypad.
The keypad interrupted parameter upload to the drive.
Parameter reading has failed.
A Download procedure was queried, but no parameter is saved to the flash
memory.
Wait until the system completes the operation required.
Parameter save is not allowed.
The keypad interrupted parameter download to the drive. Parameter writing has
failed. As a result, not all parameters have been updated (parameter
inconsistency).
UPLOAD impossible.
The required function is not available at the moment.
The required function is inhibited because the drive is running.
Download failed because parameters saved to keypad memory relate to a SW
version or product ID incompatible with the drive SW version or product ID.
Download preliminary operation underway, the system is checking the integrity
and compatibility of the parameters saved in the keypad memory.
Open and close the START input to start the drive.
Open and close the ENABLE-A and ENABLE-B inputs.
Writing procedure impossible.
Illegal value entered, operation failed.
Writing procedure impossible because Control is active and the drive is running.
Illegal address entered, operation failed.
The drive is disabled and does not acknowledge the ENABLE-A and ENABLE-B
inputs because it is writing a Cxxx parameter.
W37
ENABLE LOCKED
CAUTION The drive will start up as soon as writing is over!!!
W38
LOCKED
Editing mode cannot be accessed because parameter modification is disabled:
P000 is different from P002.
33/69