Download Manuales del programador

Transcript
Manuales del programador
Página 58 de 107
Error
Number
(Hex)
80
Error Tag
E_ILLEGAL_DIGIT
Description
One or more characters sent in the command could not be
correctly converted to a digit (hex or decimal).
81
E_BAD_ADDRESS
The command is valid, but the addressed module does not
support the command received.
82
E_INBUF_FRMERR
The FieldPoint network module detected a serial framing
error in the command. The command was ignored.
83
E_NO_MODULE
The addressed module does not exist.
84
E_INV_CHNL
One or more channels specified in the command either do
not exist or do not support the operation specified. The
command was ignored.
85
E_INV_RANGE
One or more ranges specified in the command either do not
exist or do not support the setting specified. The command
was ignored.
86
E_INV_ATTR
One or more attributes specified in the command either do
not exist or do not support the setting specified. The
command was ignored.
88
E_HOTSWAP
The module has been hot-swapped since it was last sent a
command. This response is sent only if the network module
is enabled to report hot-swaps, and if the hot-swap occurred
after hot-swap reporting mode was enabled. The command
was ignored. This error number can be sent in response to a
standard command if you have enabled hot-swap reporting
for the bank.
89
E_ADDR_NOT_SAME
The module addressed by the Resend Last Response is not
the same as the module addressed by the previous
command.
8A
E_NO_RESEND_BUF
The response to the last command is unavailable
8B
E_HW_FAILURE
An irrecoverable fault has occurred.
8C
E_UNKNOWN
An unidentifiable error condition has occurred.
Tabla 2.6 Extended Error Responses
Conjunto de drivers para tarjetas de adquisición de señales bajo Linux