Download Untitled - Sea

SEA-DOO WATERCRAFT
SPECIFICATION BOOKLET
2004 EDITION DIFFERENCES WITH 1988-2003
Were added:
– 2004 models
– Injector and sensor resistance values were integrated in Carburetion Section.
– Distinction between 2-Stroke and 4-TEC engines in Engine Tightening
Torque Section.
The purpose of this manual is to facilitate access to watercraft specifications. The Specification Booklet acts like a
summary of the technical data included in the Shop Manual.
For a more complete information, refer to Shop Manual.
Specifications which are more commonly used for the maintenance and repair of the different Sea-Doo® watercraft for
the years specified on cover page, are grouped in sections.
This edition was primarily published to be used by watercraft
technicians who are already familiar with all service and
maintenance procedures relating to Sea-Doo watercraft.
NOTICE:Bombardier Recreational Products Inc. (BRP) is not
responsible for typesetting errors.
Were removed:
– 1988 to 1999 models
Were revised:
– minor corrections were done as per latest technical information available
The contents of this booklet is applicable to the particular
product at its time of manufacture. However it may include
later component improvements authorized by BRP. See footnotes and read all appropriate bulletins.
The use of genuine BRP parts is strongly recommended
when considering replacement of any component. Dealer
and/or distributor assistance should be sought in case of
doubt.
MODIFICATIONS DE L’ÉDITION 2004
PAR RAPPORT À CELLE DE 1988-2003
Ajouts:
– modèles 2004
– Les valeurs de résistance des injecteurs et des capteurs ont été intégrées
à la section Carburation.
– Distinction entre les moteurs 2-temps et les moteurs 4-TEC dans la section Couples de serrage du moteur.
Retrait:
– modèles 1988 à 1999
Révision:
– Des corrections mineures furent apportées conformément aux
informations techniques les plus récentes.
(Smt2004-001a_intro.fm SH)
Torque tightening specifications must be strictly adhered to.
Locking devices (ex.: lock nut/tab, locking disks, self-locking
fasteners, etc.) must be installed or replaced with new ones,
where specified. If the efficiency of a locking device is
impaired, it must be renewed.
BRP disclaims liability for all damages and/or injuries resulting from the improper use of the contents. We strongly recommend that any service be carried out and/or verified by a
highly-skilled professional technician. It is understood that
certain modifications may render the use of the watercraft
illegal under existing federal, provincial and state regulations.
BRP reserves the right at any time to discontinue or change
specifications, designs, features, models or equipment without incurring obligation.
(Smt2004-001a_intro.fm SH)
I