Download VM 020 CD RECEIVER
Transcript
Installation problems: Causes and Remedies If you suspect something is wrong, immediately switch power off. Immediately stop using it and call the store where you purchased it. Never try to repair the unit yourself because it is dangerous to do so. SYMPTOM CAUSE REMEDY GENERAL No power Car engine switched off. Cable is not correctly connected. Fuse is burnt. No sound Turn on the car ignition ACC o ON Check connection. Replace fuse. Check volume or mute on/off. If the above solutions cannot help, press the RESET hole. DISC Disc is inserted but no sound. Disc with label showing downward Disc dirty or damaged. Turn disc to have label showing upward. Clean or replace disc. Disc sound skips, tone quality is low Disc dirty or damaged. Clean or replace disc. Sound skips due to vibration Mounting angle is over 30°. Unit is not firmy fixed. Reduce inclination. Mount the unit securely with the mounting parts. Interference on reception of radio-station Station too far or signal too weak. Select another radio-station. Loss of the memorized radio stations Current-supply cables are not correctly connected. Check the permanent +12V. Radio-modality does not give any audio Front-Panel has been taken off, without having first switched-off the appliance and then the board of instruments. If you intend to maintain the procedure of taking the front-panel directly off, you have to effect the RESET and connect the red cable (under key) directly to the battery. This will resolve both cause 1 and 2. Current-supply under key is NOT in order. Thank you for your kind attention. RADIO ERROR MESSAGES ON THE DISPLAY 40 NO FILE: Disc is not CD or contains non MP3 files. ERR-4: Disc upside down. ERR-10: Recovery error, check the disc. ERR-11: MP3 error, check the disc. ERR-12: USB/SD/MMC error, check the file. ERR-3 o ERR-7: Disc mechanism error: press to eject the disc. In case thath the disc cannot be ejected press the RESET switch and press eject again.