Download VM 020 CD RECEIVER

Transcript
Installation problems: Causes and Remedies
If you suspect something is wrong, immediately switch power off. Immediately stop using it and call
the store where you purchased it. Never try to repair the unit yourself because it is dangerous to do so.
SYMPTOM
CAUSE
REMEDY
GENERAL
No power
Car engine switched off.
Cable is not correctly connected.
Fuse is burnt.
No sound
Turn on the car ignition
ACC o ON
Check connection.
Replace fuse.
Check volume or mute on/off.
If the above solutions cannot help, press the RESET hole.
DISC
Disc is inserted
but no sound.
Disc with label showing downward
Disc dirty or damaged.
Turn disc to have label showing upward.
Clean or replace disc.
Disc sound skips, tone
quality is low
Disc dirty or damaged.
Clean or replace disc.
Sound skips due
to vibration
Mounting angle is over 30°.
Unit is not firmy fixed.
Reduce inclination.
Mount the unit securely with the
mounting parts.
Interference on reception
of radio-station
Station too far or signal too weak.
Select another radio-station.
Loss of the memorized
radio stations
Current-supply cables are not
correctly connected.
Check the permanent +12V.
Radio-modality does not
give any audio
Front-Panel has been taken off, without
having first switched-off the appliance
and then the board of instruments.
If you intend to maintain the procedure of
taking the front-panel directly off, you have
to effect the RESET and connect the red
cable (under key) directly to the battery. This
will resolve both cause 1 and 2.
Current-supply under key is NOT in
order.
Thank you for your kind attention.
RADIO
ERROR MESSAGES ON THE DISPLAY
40
NO FILE: Disc is not CD or contains non MP3 files.
ERR-4: Disc upside down.
ERR-10: Recovery error, check the disc.
ERR-11: MP3 error, check the disc.
ERR-12: USB/SD/MMC error, check the file.
ERR-3 o ERR-7: Disc mechanism error: press to eject the disc.
In case thath the disc cannot be ejected press the
RESET switch and press eject again.