Download Installation Manual

INSTALLATION (cont.)
INSTALL BATTERIES
Ensure all control/remote system components are in the
OFF position prior to installing any batteries.
Remote transmitter:
The remote transmitter requires 3 AAA batteries (included)
to operate.
Remove lid
for battery
access
1. Locate the remote transmitter, remove the lid (found
on rear), and properly insert the batteries as marked.
Re-secure the lid. See Fig. 21-1.
Remote receiver:
Fig. 21-1 Install transmitter batteries
The remote receiver requires 4 AA batteries (included to
operate. Turn off gas to the unit. Locate the receiver on
the control box, which is located on the left side of the
unit (see Fig. 21-2).
(Direct
vent
insert)
2. Slide the 3-position switch on the receiver to the ON
position, then remove the switch. Unfasten the plastic
plate using a Phillips screwdriver. See Fig. 21-3.
Remove the battery lid (push in tabs) and properly
insert the batteries as marked (see Fig. 21-4). Resecure the lid, the plate, and the switch.
ON
Remote
receiver
REMOTE
PRG
OFF
Fig. 21-2 Control box (left side of unit)
ON
Move to ON
position, then
remove
REMOTE
A
Unscrew,
then remove
plate
PRG
OFF
B
Fig. 21-3 Remove switch and plate
for battery access
Battery lid
Fig. 21-4 Install receiver batteries
21