Download KTC-9090DAB
Transcript
Installation Procedure 2CAUTION • Do not connect the DAB control cable whilst the control unit is turned ON. • Be sure to press the reset button on the control unit after installation. • If your car is not prepared for this special connection-system, consult your Kenwood dealer. • Make sure that all cable connections are securely made by inserting jacks until they lock completely. • Do not let unconnected cables or terminals touch metal on the car or anything else conducting electricity. To prevent short circuits, also do not remove the caps on the ends of the unconnected cables or the terminals. • Some disc changers need conversion cables for connection. See the section on "Safety Precautions" for details. • Insulate unconnected cables with vinyl tape or other similar material. • Be sure to use the provided DAB antenna (Accessory 7, 8) as the DAB antenna. Using other antenna than provide may lead to malfunction. • Take care so that the antenna cable and other connection cables are not caught by mobile parts. Otherwise cable disconnection or other trouble may result. • Do not apply too much force on the antenna cable, other connection cables and connectors by bending a cable, etc. Otherwise cable disconnection or other trouble may result. • Securely fasten the screws that fix the DAB antenna as well as the screws of the DAB antenna itself. Screws that loosen introduce the danger of the antenna coming apart during travel. • DC voltage is output from the DAB antenna terminal of the DAB hideaway tuner to supply power to the DAB antenna. Be sure to connect the supplied DAB antenna only. Otherwise, the unit may be damaged. • After the unit is installed, check whether the brake lamps, indicators, wipers, etc. on the car are working properly. English 1. To prevent short circuits, remove the key from the ignition and disconnect the terminal of the battery. 2. Install the DAB antenna and connect the antenna cable to the DAB hideaway tuner. 3. Connect the DAB hideaway tuner and the control unit using the provided DAB connection cable. 4. Make the proper input and output cable connections for each unit. 5. Install the unit in your car. 6. Reconnect the - terminal of the battery. 7. Press the reset button on the control unit. 25