Download 1 - Kyosho
Transcript
13 ギヤボックス Gear Box 船体 Hull 4 x 4mm セットビス Set Screw ここでは接着しない。 Don't pour instant glue at here. 1 六角レンチ(2.0mm) Hex Wrench (2.0mm) 平らな面にセットビス を固定する。 Firmly tighten the set screw onto the flat spot. 4x4mm 接着面に油分や汚れをつけない。 Glued surface should be free from any oil residues and dirt. 船底の接着面をサンドペーパー であらしておく。 Abrade the glued surface with sandpaper. 37 14 船体 Hull < CHECK 1 > < CHECK 2 > < CHECK 3 > 37 4mm 21 船底 Bottom 12mm 船底と 21 のすき間をあけない。 Make sure that there is no gap. 37 が中心になるようにする。 Make sure that 37 runs parallel to the center line of the boat. CHECK1∼3を確認のあと、21 と 船底のすき間に瞬間接着剤を流し 込んで接着する。 After positioning, pour instant glue into the space around 21 . 21 瞬間接着剤で接着する。 Apply instant glue (CA glue, super glue). 左右同じように組立てる。 Assemble left and right sides the same way. 21 注意して組立てる所。 Pay close attention here!
This document in other languages