Download SurroundControl 31960

7.2.10 | The Mono Key
This key switches the mono signal to the channel(s) selected
with the Mono Mode function in the Monitoring instrument
(MONITORING). The function selected in the Toolbar remains
activated until the Close button is selected. In this way, the
effects of different settings can be compared. In window 4
(Status Box), the message „Mono active“ is displayed.
Please proceed as follows to select the Mono mode :
1.
Press the INSTR button until window 3 gets the white
frame.
2.
Press the MODE button on the left to switch from Function Select mode to Instrument Select mode.
3.
Press button 7 labelled MONITORING. The Monitoring
instrument is displayed in window 3 and the Toolbar
switches to the Function Select mode for the Monitoring
instrument.
4.
Press button 1 labelled Mono Mode. Now you can select
the channels or channel groups to which the mono signal
should be switched.
5.
After having selected your preferred channel or channel
group, press the Close button to get back to the Monitoring instrument functions.
6.
Press the M key. The mono signal is switched to the
selected channel or channel group.
EN
7.2.11 | The Volume control
This control adjusts the listening volume. The volume control
sensitivity (Vol Sens) can be set in the MONITORING instrument spreading the level range that can be passed through by
a fast turn of the volume control.
In all modes, pressing the Volume control retrieves and sets
the preset value stored with the CS channel key. The Downmix-Direct-Out signals DLo, DRo and DMo are not affected by
the volume control setting.
The volume control is also used in the CAL instrument for setting trim and delay values for individual channels. To do so, hold
down the Trim or Delay button and simultaneously turn the
volume control. In Multi-Channel modes, the control is used to
select one of the Listening Groups.
If the Adding Mode, push volume knob for global reset
check box is activated on the Key Settings menu, all channels
can be set back to the basic position by pressing the volume
control.
Please proceed as follows to select the volume control
sensitivity for fast movements:
1.
Press the INSTR button on the right until window 3 gets
the white frame.
2.
Press the MODE button on the left to switch from Function Select mode to Instrument Select mode.
3.
Press button 7 labelled MONITORING. The Monitoring
instrument is displayed in window 3 and the Toolbar
switches to the Function Select mode for the Monitoring
instrument.
SurroundControl 31900/31960 Series
4.
Press button 5 labelled Vol Sens until you have selected the sensitivity option you prefer: low (L) for a small
volume level range that can be passed through with one
turn, middle (M) for a middle range or high (H) for a large
range. The selected option is highlighted on the button in
the Toolbar.
5.
Now you can use the volume control with the selected
sensitivity.
7 | Control | 7.2 | Using the Control Elements
EN-45