Download TRAIN-NAVIGATION

You have set up a single track to operate a station stop in it. The allocated navigation receiver is programmed as per the following:
CV Value Type
0
14 1. Adress
(Module address)
1
0
2. Address
2
6
Operation style
3
2
Direction
4
45 Waiting time to operate
5
0
Waiting time to switch
accessory
6
18 Signal
7
0
1. Accessory/feed-back
address
CV Value Type
8
0
2. Accessory/feed-back
address
9
0
10
0
11
0
12
0
13
0
14
15
0
0
Func
CV
2...
3...
4...
Sensor 1
...0
...1
...2
...3
...4
Sensor 2
...5
...6
...7
...8
...9
Speed
CV
5...
6...
7...
Sensor 1
...0
...1
...2
...3
...4
Sensor 2
...5
...6
...7
...8
...9
MA
CV
8...
9...
10...
Sensor 1
...0
...1
...2
...3
...4
Sensor 2
...5
...6
...7
...8
...9
What do these entries actually mean?
•
•
•
•
•
•
•
The navigation receiver has the LocoNet-address 14 (LNCV0)
The operation style is station stop (LNCV2=6)
The station stop is active by running over the sensors in any direction (LNCV3)
On departure in direction Sensor 1 -> Sensor 2, the signal with address 18 (LNCV6) will
be set to green, in direction Sensor 2 -> Sensor 1 automatically the signal with the by
value 1 increased address 19 is set to green
The loco will wait for 45 seconds (LNCV4), before its own exit signal (18 or 19, dependent on the direction) is set to green before departure
On entering the station stop area, no additional electrical accessory is to be switched
(LNCV7=0, LNCV8=0)
Functions of the switching operation will not be called up
139