Download Modulare System Management Konsole Modular System

Transcript
Installation and commissioning
Connecting the devices with USB cables
To operate the Pilot/Center and all expansion units on the table or installed as separate units, you must connect the devices with each other via USB cables.
1.
2.
Connect the expansion units on the right and left with the Pilot/Center. To do so,
insert the USB cable into a USB slot on the back of the Pilot/Center and into a
slot on the back of the expansion unit.
To operate two expansion units side by side, you connect an expansion unit to
the Pilot/Center and then connect the two expansion units together. To do so,
connect a USB cable into a USB slot on the back of both expansion units.
Devices with S-connectors
Alternatively, you can also connect the Pilot/Center directly to the expansion units
to use them as a tabletop or installed device. In this case, the GEUTEBRÜCK S
connector can be used.
Caution
The component can be destroyed by electrostatic discharge.
Ensure suitable ESD protection!
Ground yourself with a grounding strap before you remove the S-connector from the
protective packaging and insert it.
1.
Remove the side covers – if already mounted – by pushing the side cover on the
side of the device.
Figure 9: Removing the side panel
Note
22
Geutebrück recommends operating the devices in the form shown here, as this
makes it possible to also realize a redundant power supply.
ÆSee the chapter Operating devices with redundant power supply on page 22.
V 1.3