Download Jet Cat (fr)

The bellcrank is installed as shown in the illustration: first press the two ballraces into the
bellcrank hub, with the spacer sleeve between them, then fix the linkage balls to the outermost
holes of the arms using M2 x 8 screws. Note that the ball for the pushrod running to the servo
must be fitted on the outside, the ball for the pushrod running to the swashplate on the inside.
Mount the bellcrank on the chassis using an M3 x 20 socket-head cap screw, spacer ring and
self-locking nut.
1.5 Assembling the pushrods (bag J2-1B)
Pushrods A
Make up two pushrods as shown in the drawing, using M2.5 x 30 threaded rods and two balllinks.
Pushrods B
Make up two pushrods as shown in the drawing, using M2.5 x 65 threaded rods and two balllinks.
Pushrods C
Make up two pushrods as shown in the drawing, using M2.5 x 75 threaded rods and two balllinks.
11