Download LD 6100 - Plasmon

Observe the following precautions to assure data integrity when handling or storing the media cartridge:
1) Do not drop the media cartridge onto hard surfaces.
2) Do not physically abuse the cartridge exterior or access mechanisms.
3) Do not store the media cartridge in the drive.
4) Remove cartridges from the drive when the drive is going to be moved.
5) Apply labels only in designated areas. Refer to the Affixing Labels to the Media Cartridge
section for instructions on label placement.
6) Avoid exposing the media cartridge to direct sunlight and condensation.
CAUTION
Careful attention to the environmental constraints specified in the LM
6000 Media Specification (P/N 97647044) is strongly recommended
to prevent damage to the media.
7) Do not expose the media cartridge to temperature extremes.
8) Stabilize the media cartridge to the specified operating temperature range 1 hour before
use.
9) Do not open the media access shutter.
10) Do not touch the disk surface through the media access shutter.
11) Do not remove the disk from the cartridge.
12) Use, handle and store the media cartridge in clean office conditions.
13) Do not smoke while handling the media cartridge. Smoke is a prime source of disk
contamination. All smoking materials should be kept away from areas where media
cartridges are in use or stored.
14) Keep external surfaces of the cartridge clean. Dust the cartridge periodically with a soft,
dry, lint-free cloth.
For more information concerning media care and handling, refer to the LM 6000 Media Specification
(P/N 97647044).
PLASMON LASER MAGNETIC STORAGE - LD 6100 USER MANUAL
Page 78