Download REFERENCE & INSTALLATION MANUAL

PART 8: REPORTING AND DIALER SETTINGS
The following section explains all the features and options that must be programmed in order for your security system to
properly report system events to a central station. When an event (e.g. zone in alarm) occurs in the system, the control panel
verifies if a report code was programmed in the section corresponding to the event (except Ademco Contact ID “All Codes”).
If a report code was programmed, the control panel will dial the central station telephone number defined by the Event Call
Direction feature. When the central station answers, the control panel will transmit the System Account Code, followed by the
programmed Report Code.
Figure 8-1: Event Reporting
Reporting/Dialer
Option [3] - Section [135]
Partition Account Number 1
3 or 4 digits (0-F) in Section [143]
Partition 1
Related Features
Partition Account
Numbers
Delay Before Alarm Transmission
Section [080]
Reporting Account Number 2
3 or 4 digits (0-F) in Section [144]
Partition 2
Pager Format Delay Transmission
Section [083]
Recent Closing Delay
Section [085]
Central Station Telephone Numbers 1 & 2
Sections [151] & [152]
Power Failure Report Delay
Section [086]
Back-up Number
Section [153]
Auto Test Report
Sections [087] & [110]
Report Disarm Options
Option [1] - Section [131]
Event Call Direction
Defines which Central Station Telephone Numbers each group of
events will report to.
Report Zone Restore Options
Option [6] - Section [132]
Option
Option
Option
Option
Option
Option
[1]
[2]
[3]
[4]
[5]
[6]
ON
ON
ON
ON
ON
ON
Section [137]
= Call Telephone #1 for Arm/Disarm Report Codes
= Call Telephone #2 for Arm/Disarm Report Codes
= Call Telephone #1 for Alarm/Restore Report Codes
= Call Telephone #2 for Alarm/Restore Report Codes
= Call Telephone #1 for Tamper/Restore Report Codes
= Call Telephone #2 for Tamper/Restore Report Codes
Option
Option
Option
Option
[1]
[2]
[3]
[4]
ON
ON
ON
ON
Section [138]
= Call Telephone #1 for Trouble/Restore Report Codes
= Call Telephone #2 for Trouble/Restore Report Codes
= Call Telephone #1 for Special System Report Codes
= Call Telephone #2 for Special System Report Codes
[1] = Ademco Slow
Pulse
[2] = Silent Knight Fast
[3] = Sescoa
Reporting Formats
Section [140]
1st digit = CSTN#1
2nd digit = CSTN#2
[4] = Ademco Express
DTMF
(Tone)
[6] = Pager
Alternate Dial
Option [4] - Section [136]
Maximum Dialing Attempts
Section [081]
Program 1 or 2-digit (1-FF)
report codes into sections
[160] to [213] where each
section represents up to 4
events in the system.
Delay Between Dialing
Attempts
Section [082]
Program the 2-digit report
codes corresponding to the
Contact I.D. Table into
sections [160] to [213] where
each section represents up to
four events in the system.
Program FF to use the default
Contact ID Report Code .
"Programmable"
Option [3] OFF - Section [136]
[5] = Ademco Contact ID
"All Codes"
Option [3] ON - Section [136]
The control panel
automatically generates
all report codes. You do
not have to program any
report codes.
S PECTRA S ERIES 31