Download User's Manual
Transcript
3 Upper Thread Holder 1) Install upper thread holder A. Install the upper thread holding device ⓐ Remove the finger guard and the timing belt cover of the needle bar ⓑ Install the face plate and the face plate gasket③ by using the face plate screws② after remove the face plate①. ① ③ ② ④ [ Fig. 26 ] B. Connecting air hoses ⓐ Attach the manifold bracket(D)① to the back of the table using the screw②. ⓑ Remove the plug④ of the main solenoid valve③ and install the joint⑤. ⓒ Link the joint⑤ and the nipple⑦ using the air hose⑥(ф6). ⓓ Insert the air hoses 26 , 27 , 28 of the upper thread holder to the related places of the solenoid valve⑧ respectively. ⑤ ④ ⑥ ① ② ⑧ ③ ⑦ ⑥ [ Fig. 27 ] 56