Download SERVICE MANUAL

APPENDIX 1 WORKER SWITCH Settings (WSW)
This appendix describes the functions of the Worker switches, which can be divided into two
groups: one is for customizing preferences designed for the shipping destination (Refer to
"1.4.16 EEPROM Customizing (Function code 74)" in Chapter 5) and the other is for
modifying preferences that match the machine to the environmental conditions. Use the latter
group if the machine malfunctions due to mismatching.
Each switch has eight selectors. However, some of them cannot be set by an end user. Only
selectors in the worker switch setting tables of this Appendix that are shaded can be set by
an end user.
The worker switch setting procedure is described in Chapter 5, Section 1.4.6 [ 1 ] Worker
Switch Setting (Function code 10).
■ Worker Switch
WSW No.
Function
Refer to:
WSW01
Dial pulse setting
App. 1-3
WSW02
Tone signal setting
App. 1-5
WSW03
PABX mode setting
App. 1-6
WSW04
Transfer facility setting
App. 1-8
WSW05
1st dial tone and busy tone detection
App. 1-9
WSW06
Redial/Pause button setting and 2nd dial tone detection
App. 1-10
WSW07
Dial tone setting 1
App. 1-12
WSW08
Dial tone setting 2
App. 1-13
WSW09
Protocol definition 1
App. 1-14
WSW10
Protocol definition 2
App. 1-15
WSW11
Busy tone setting
App. 1-16
WSW12
Signal detection condition setting
App. 1-17
WSW13
Modem setting
App. 1-18
WSW14
AUTO ANS facility setting
App. 1-19
WSW15
Redial facility setting
App. 1-20
WSW16
Function setting 1
App. 1-21
WSW17
Function setting 2
App. 1-22
WSW18
Function setting 3
App. 1-23
WSW19
Transmission speed setting
App. 1-24
WSW20
Overseas communications mode setting
App. 1-25
WSW21
TAD setting 1
App. 1-26
WSW22
ECM and call waiting caller ID
App. 1-27
WSW23
Communications setting
App. 1-28
WSW24
TAD setting 2
App. 1-29
WSW25
TAD setting 3
App. 1-30
WSW26
Function setting 4
App. 1-31
WSW27
Function setting 5
App. 1-32
App. 1-1
Confidential