Download User Guide «

Transcript
NetBootLoader
Command Syntax
PCI
FUNCTION:
SYNTAX:
DESCRIPTION:
Display PCI information
pci
The command PCI is used to display detailed information on all
detected PCI devices. The bus number, device number, function
number, vendor, and device ID’s are displayed together with the
configured base addresses and the assigned IRQ number.
PF
FUNCTION:
SYNTAX:
Set or display the serial port parameters (format)
pf [<port> [<baud>][/[<bitschar>]
…[/[<parity>][/<stops>]]]]
where:
pf
<port>
<baud>
<bitschar>
<parity>
<stops>
ID 1022-8317, Rev. 2.0
command
parameter: string:
“term” or “ser0”
defines serial port to be configured
(term = primary; ser0 = scondary)
parameter: numeric string:
“300, 600, 1200, 1800, 2000, 2400, 3600, 4800,
7200, 9600, 19200, 38400, 115200”
defines the baud rate for the port
parameter: numeric string:
“7” or “8”
defines the number of bits per character
parameter: string:
“n” (none), “o” (odd), “e” (even)
defines parity to be used
parameter: number string:
“1” or “2”
defines number of stop bits
Page 61