Download Complete Installation Manual

STEP 2 – CLAMP REMOVAL
•
Unbolt and remove clamp section of the 3-part clamp drain.
If you are installing the recommended 3-part clamp drain supplied with
your OneLiner Kit, check local plumbing codes for proper installation
required for your area. You may need a qualified plumber for this step.
STEP 3 – PRE-PITCH STICKS
The Pre-Pitch Kit is installed to ensure that all secondary water flows to the
drain to help eliminate mold and mildew created by standing water.
Measure approx.1” from drain to outside perimeter of shower. (A) Cut the (6) PrePitch sticks provided as shown. (B) Attach 2-1” two-way adhesive strips
(supplied) to the bottom of the Pre-Pitch sticks, one on each end. (C) Press firmly
in place approx 2 to 2 ½ ft. apart from each other. (D) Adhesive strips facing down
onto sub-floor. **Pre-Pitch Kit has replaced the previous wooden bars**
A
B
4
C
D