Download Moore 353 USER'S MANUAL

Installation
UM353-1
8.4.13 Wiring to a Model 363 VIEWPAC Recorder
Figure 8-25 shows the wiring needed to connect a Model 363 analog input to a Moore 353 analog input. As shown,
a 1-5 Vdc transmitter input to the Moore 353 is also routed the recorder’s Analog Input 1.
Model 363 VIEWPAC
Recorder Terminals
Model 353A or 354/354N
Controller Terminals
External
Power
120/240 Vac
25W
47-63 Hz
Hot
H
H
Neutral
N
N
Earth Ground
G
G
5
A5 Recorder
Analog Input 1,
A6 See note 2
26 Vdc
Analog Input,
+
e.g. Model 340 or
SITRANS P DSIII,
_
2-Wire Transmitter,
4-20 mA Output
1-5 Vdc
250
20
AIN1
18
Station
Common
_ Analog Input,
e.g. Model 340 or
SITRANS P DSIII,
+ 2-Wire Transmitter,
4-20 mA Output
A7
Recorder
Analog Input 2,
See note 2
A8
X03109S3
_
+
Power Supply
Common Ground Bus
Earth
Ground
Recorder
Power Input
and Ground,
See note 3
Notes:
1. See UM353-1, UM354-1, or UM354N-1, Table 8.1 for AIN2, 3, and 4 terminals.
2. Recorder inputs are isolated 1-5 Vdc, Refer to UM363-1 for other Recorder analog inputs.
3. Refer to UM363-1 for power requirements and detailed wiring and grounding information.
FIGURE 8-25 Moore 353 To Model 363 VIEWPAC Analog Input Wiring
8.4.14 Power Wiring
Basic connections for AC and DC power input are shown in Figure 8-26. Wiring guidelines are given in Section
8.4.2.
Model 353A
Rear Terminals
X03106S0
H
Neutral
N
Earth Ground
G
H
AC To DC
Power Supply
on
MPU Board
=Terminal on rear of case.
External
Power
24 Vdc
25W
(+)
H
(-)
N
Earth Ground
DC To DC
Power Supply
on
MPU Board
G
Controller Circuitry
Hot
Controller Circuitry
External
Power
120/240 Vac
25W
47-63 Hz
Model 353D
Rear Terminals
G = Green screw at top center of rear terminal area.
FIGURE 8-26 Controller Power Wiring
8-24
March 2003