Download Cisco Service and Application Module for IP User Guide

Appendix B
Supervisor Console Commands
hw-module boot
hw-module boot
To specify the boot options for the module through the power management bus control register, use the
hw-module boot command in privileged EXEC mode.
hw-module module num boot [value] {config-register | eobc | flash image | rom-monitor}
Syntax Description
module num
Specifies the number of the module to apply the command.
boot value
(Optional) Literal value for the module's boot option; valid values are from
0 to 15. See the “Usage Guidelines” section for additional information.
config-register
Boots using the module’s config-register value.
eobc
Boots using an image downloaded through EOBC.
flash image
Specifies the image number in the module’s internal flash memory for the
module’s boot option; valid values are 1 and 2.
rom-monitor
Stays in ROM-monitor mode after the module resets.
Defaults
This command has no default settings.
Command Modes
Privileged EXEC
Command History
Release
Modification
12.2(18)SXF
Support for this command was introduced on the Supervisor Engine 720.
12.2(33)SRA
This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2(33)SRB1
This command was integrated into Cisco IOS Release 12.3(22)SRB1.
12.2(33)SRC
This command was integrated into Cisco IOS Release 12.2(33)SRC.
12.2(33)SRD
This command was integrated into Cisco IOS Release 12.2(33)SRD.
Usage Guidelines
The valid values for the boot value argument are as follows:
0—Specifies the module’s config-register value.
1—Specifies the first image in the flash memory.
2—Specifies the second image in the flash memory.
3—Stays in ROM-monitor mode after the module reset.
4—Specifies the download image through EOBC.
Cisco Service and Application Module for IP User Guide
OL-13003-06
B-19