Download Installation Guide

4 Operation
SNMP Community
Access
Configuration
The SNMP Community Access Configuration screen allows you to view and alter parameters for SNMP community access operations.
The SNMP Community Access Configuration screen is shown in Figure 4-10.
********************** SNMP Community Access Configuration *********************
Name: F@43802
Community
Community
Community
Community
Community
Community
#1
#2
#3
#4
#5
#6
Name
Name
Name
Name
Name
Name
[C1=]: public
[C2=]:
[C3=]:
[C4=]:
[C5=]:
[C6=]:
Comm #1 Access [A1=]
1) Read Only
>>2) Read/Write<<
3) None
Comm #2 Access [A2=]
1) Read Only
>>2) Read/Write<<
3) None
Comm #3 Access [A3=]
1) Read Only
>>2) Read/Write<<
3) None
Comm #4 Access [A4=]
1) Read Only
>>2) Read/Write<<
3) None
Comm #5 Access [A5=]
1) Read Only
>>2) Read/Write<<
3) None
Comm #6 Access [A6=]
1) Read Only
>>2) Read/Write<<
3) None
NOTE: Each Name entry must be made individually.
Help[?]
Save[SA]
Cancel[X]
>
Figure 4-10 SNMP Community Access Configuration Screen
1. Community # n (1-6) Name - Community names to which the unit belongs.
These commands [Cn] must be entered individually, not with other fields.
2. Comm # n (1-6) Access - Setting for Read/Write access in each of the
communities.
NOTE: Settings may only be changed after login with Supervisor password.
Default values for these settings are as shown in Figure 4-10.
Commands:
Help [?] - Advances to “Help” for SNMP Community Access Configuration screen.
Save [SA] - Saves parameters and returns to System View screen.
Cancel [X] - Returns to System View screen without saving changes.
Save the SNMP Community Configuration changes when they are all set correctly by
entering “SA” followed by ENTER. Also returns the user to the System View screen.
Proceed to Trap Configuration, selecting [TC] by typing “TC” followed by ENTER.
4-20
NetPath 100 User’s Manual - Installation Guide
980-001-0210K
November 2000