Download Service Manual Samm

Maintenance tasks & adjustments
5.2.4.
Replace a drive motor
Preparation
See section 5.2.1.
Procedure
1.
Remove cap A.
2.
Unfold the washer (C).
3.
Remove screw B and washer D.
4.
Remove the drive wheel (E) from the motor
axle.
•
Make sure that you do not loose the
key (I).
5.
Remove the mudguard (G) for easy access.
I
C
H
F
B
G
E
6.
7.
8.
9.
10.
11.
18
Remove the old drive motor (C)
The screws (A) and nuts (B) can be
discarded.
Install the new motor.
Use the screws and nuts that are enclosed
with the new motor.
Install the mudguard.
Install the drive wheel.
a. Put some grease on the axle to prevent
fretting.
b. Mount the drive wheel on the axle.
c. Make sure to lock the nut by folding the
washer.
Make sure that the drive wheel does not
interfere with the motor.
Install the motor arm on the wheelchair. See
section 5.2.5.
D C A
A
Service manual - Samm
B
C