Download NanoWizard User Manual - Section for Nanostructure Physics
Transcript
8.6 Manipulation and lithography Manipulation allows the user the flexibility to define paths over the sample surface that the tip will follow. In imaging mode, the tip moves back and forth in straight lines across the sample, and in force spectroscopy the tip moves vertically over a specified point. In manipulation mode, the tip moves freely across the surface, along user-specified paths. Between the paths the tip is lifted from the surface so a series of disconnected lines can be drawn. Change to Manipulation mode using the Measurement Mode drop-down box. The chosen mode is bordered in green and displayed in the first line. The manipulation mode can be used for two main kinds of experiments: • The tip can be used to move particles or molecules around on the surface (nano-manipulation). • The tip can be used to draw a pattern across the sample, e.g. scratching with a higher force (nano-scribing). During manipulation, it may be useful to calculate the applied forces, to choose suitable values for manipulation of the surface or objects lying on the surface. Often stiff cantilevers may be used, in which case the thermal noise calculation is not appropriate, but the spring constant supplied by the manufacturer should be sufficient for a general estimate of the applied forces. Typical forces used in < 1 nN in any case nano-manipulation < 500 pN to move molecules in case of H-bonds between molecule and its support ~ 100 pN to move molecules Nano-scribing ~ 5 nN, depending on the material Other manipulation experiments can involve applying a voltage to the tip (e.g. local oxidation) or using a functionalized tip to create some surface modification along the manipulation paths. In this case the manipulation force will probably be kept to a minimum, as for imaging, since some other mechanism will create the surface pattern or modification. ® NanoWizard AFM User Manual Version 4.2 131