Download C Compiler V3 user's Guide

Transcript
C Compiler V3 user's Guide
4. Inline function definition:
Built-in Function
Description
GCC_RL(varname)[1]
varname rotates left without carry
GCC_RLC(varname) [1]
varname rotates left with carry
GCC_RR(varname) [1]
varname rotates right without carry
GCC_RRC(varname) [1]
varname rotates right with carry
GCC_NOP()/_nop()
execute a dummy instruction (NOP)
GCC_SWAP(varname) [1]
exchange the first four bits and the last four bits of varname
GCC_HALT()/_halt()
execute a HALT instruction
GCC_CLRWDT()/_clrwdt()
clear the watchdog timer (CLRWDT)
GCC_CLRWDT2()/_clrwdt2()
clear the watchdog timer (CLRWDT2)
GCC_CLRWDT1()/_clrwdt1()
clear the watchdog timer (CLRWDT1)
GCC_DELAY(n) [2]
Delay n instructions
Note: [1] varname must be a 8-bit variable
[2] 0 <= n < 263690
5. If MCU contains EEPROM, then define __EEPROM_DATA (a, b, c, d, e, f, g, h);
Using this statement to write a value to EEPROM:
#define ___mkstr(x)
#x
#define __EEPROM_DATA(a, b, c, d, e, f, g, h) \
asm(“eeprom_data .section ‘eeprom’”); \
asm(“db\t” ___mkstr(a));
\
asm(“db\t” ___mkstr(b));
\
asm(“db\t” ___mkstr(c));
\
asm(“db\t” ___mkstr(d));
\
asm(“db\t” ___mkstr(e));
\
asm(“db\t” ___mkstr(f));
\
asm(“db\t” ___mkstr(g));
\
asm(“db\t” ___mkstr(h));
8 values can be written in order at once, such as:
__EEPROM_DATA(1, 2, 3, 4, 5, 6, 7, 8);
Note: __EEPROM_DATA can not be written into the function body.
Rev. 1.00
37
December 26, 2014