Download Digi Passport I-KVM User's Guide

Getting started
All the parameters are stored into the non-volatile memory space of the I-KVM, and it will
not be stored until users type "s"([s]ave). All the configuration change will be effective
after typing "a"([a]pply).
Using remote console
The IP address of the I-KVM must be known before users can access the I-KVM using the
remote console. For more information, refer to the Network Configuration section of this
document. The default I-KVM IP address is 192.168.161.5.
The remote console access function can be disabled in the remote host access option. For
more information, refer to the IP filtering in section of this document. The I-KVM
supports both Telnet and SSH protocol for remote consoles.
The following instructions will assist in setting up the Remote Console functionality:
1
Run either a Telnet (or SSH) program or a program that supports Telnet (or SSH)
functions (i.e. TeraTerm-Pro or HyperTerminal). The target IP address and the port
number must match the I-KVM. If required, specify the port number as 23 (or 22).
Type the following command in the command line interface of user's computer
telnet 192.168.161.5 (or ssh [email protected] )
or run a Telnet program with the parameters shown below::
Figure 2-8: Telnet program set up example
19