Download Cornerstone Diagnostic Imaging User Guide

Chapter 19: The IDEXX I-Vision CR* Digital Imaging System
19.5 Scanner Roller Cleaning
The roller-cleaning process enables you to clean the rollers that feed the screen from the cassette
into the scanner. Clean the rollers monthly to remove dust and small particles.
Every 1,000 scanning cycles, the software will display a message to remind you to clean the rollers.
The cleaning process requires the following:
•
A cleaning tray
•
A cleaning plate with adhesive strips (covered with protective paper) and a protective envelope
To order new cleaning plates, contact IDEXX Customer Support. In the U.S. or Canada, call
1-877-433-9948.
Note: The cleaning process is different for the Model 140 than it is for the Model 140R. Be sure to
follow the proper instructions.
14
14 x1 7
x1
4
11
x1
4
8x
10 10
24 x1 2
x3
0
8x
10 10
24 x1 2
x3
0
11
x1
4
14
14 x1 7
x1
4
Figure 19-9: The notched end of the tray goes
into the scanner. The smooth side should be up,
providing a clear path from one end of the tray
to the other.
To clean the rollers:
1.Remove any cassettes and screens from the scanner.
2. Use the menu at the top of the window to select Tools> Settings> System.
3. Select Imaging in the navigation menu on the left.
4. Click Scanner Configuration Settings.
5. Type user in the User name text box and idexx123 in the Password text box, then click Login.
After a few seconds, the User window appears.
Figure 19-10: Removing the protective paper
Note: Depending on when your system was installed, your password may begin with a
lowercase “i.” The Password text box is case-sensitive, so be sure to make a note of your exact
password.
6. Insert the cleaning tray by pushing gently until it locks into place. (See figure 19-9)
7. Remove the protective paper from the cleaning plate to expose the adhesive. Save the paper for
later.
8. Place the cleaning plate on the tray. Make sure the cleaning plate is oriented in the direction
specified on the plate.
9. In the Maintenance area, if the Dismiss button is active (blue), click it, and then click OK to reset
the cleaning reminder.
10. Click Prepare. The rollers begin to rotate.
11. Click OK to clear any messages that appear.
Figure 19-11: IMPORTANT! Let go of the plate as
soon as the rollers begin to pull it in. Resisting the
rollers will damage the scanner.
164