Download Installation / Troubleshooting Manual

Flow Homogenizer Can Replacement
1. Remove the old Flow Homogenizer
can. A Claw type oil filter wrench, or
pipe wrench may be needed.
Aluminum Base
2. Remove the Brass Tube Subassembly
and, Debris Screen, (If used) from the
old can. Install them in new can.
3. Put a coating of grease on the new
Flow Homogenizer’s rubber sealing
washer.
Tube Assembly
P/N 4001-250-00
4. Clean the Aluminum base and put a
coating of grease on the seal’s mating
surface.
5. Place new Flow Homogenizer can on
its Aluminum base. Turn until
“Finger tight”.
Rubber Sealing Washer
6. Using a band type oil filter wrench,
carefully rotate the can until tight,
approximately ¾ of a turn past finger
tight.
•
ATTENTION
Position a strip of rubber, (Bicycle
tube or rubber glove) between the
wrench and can. The rubber both
increases friction and protects the
can. Use caution as over-tightening
will buckle or collapse the can.
This is NOT a FILTER
FloScan
MOUNT WITH ARROWS UP
Flow Homogenizer Can
P/N 4001-199-03
5/14/2003
FloScan Instrument Company, Inc.
3016 NE Blakeley Street, Seattle, WA 98105
7000-144-01
Tel: (206) 524-6625
Fax: (206) 523-4961
email: [email protected] http://www.floscan.com