Download Titan Security System User Manual

Chapter 7: Administration > Administering Challenger panels
Converting Challenger V8 to software IUM:
1. Ensure the Challenger V8 panel uses firmware version 8.128 or later. Obtain
firmware if needed.
2. Go to File > Upload all from Challenger panels > Users to obtain the current
user records from the panel.
3. Power down the Challenger system.
4. Install firmware version 8.128 or later (unless already installed).
5. Reset the Challenger panel (refer to “Clearing the memory” in the Challenger
V8 & V9 Programming Manual for details).
6. Power up the panel.
7. Use RAS Install menu option 14 Defaults to program software IUM mode
(default option 95).
8. Connect with Titan.
9. Download the system back into the control panel.
10. Use the Update Raw Card Data command to create or update raw card data
for the panel’s user records (see “Updating raw card data” on page 42).
Alternatively, add hardware IUM to a Challenger V8 panel:
1. Purchase the memory module for the panel and corresponding modules for
any Intelligent Access Controllers, if applicable.
2. Go to File > Upload all from Challenger panels > Users to obtain the current
user records from the panel.
3. Power down the panel.
4. Reset the Challenger panel (refer to “Clearing the memory” in the Challenger
V8 & V9 Programming Manual for details).
5. Install the IUM modules and associated firmware (if required).
6. Power up the panel.
7. Connect with Titan.
8. Download the system back into the control panel.
9. Use the Update Raw Card Data command to create or update raw card data
for the panel’s user records (see “Updating raw card data” on page 42).
Migrating an existing Challenger V8 system to
Challenger10
The overall process to upgrade a Challenger V8 panel to Challenger10 is in two
parts.
Titan Security System User Manual
101