Download Operating instructions OSRAM OUTDOOR sensor

Control principle (normal mode)
Operation (cont.)
Luminaire
OFF
Motion?
no
yes
Artificial light required?
no
yes
Luminaire
ON
Luminaire
ON
5 s - 30 min
Motion?
no
Luminaire
OFF
no
Luminaire
OFF
yes
ja
Artificial light required?
yes
Setting the light switching theshold
Setting of the light switching threshold at which the load is
switched on or off as a function of the measured light value
(default setting: 7 lux).
If the light switching threshold is deactivated, the connected
load is switched on whenever motion is detected, independent
of the measured light value.
Changing the light switching threshold
Press button S1 briefly. The current light value measurement
is stored as the light switching threshold.
‚Confirmation: The LED flashes 1x.
S1
S2
Deactivating/activating the light switching threshold
Press button S1 for at least 2 s.
‚Confirmation: The LED flashes 2x.
When the light switching threshold is deactivated, the LED
flashes briefly every 5 s.
Setting the delay
The switch-off delay time in normal mode when no motion is
detected (default setting: 2 min).
Press button S2 briefly. The LED begins flashing.
‚Press button S2 again briefly after a delay of T (5 s –
30 min). The LED goes out. T is stored as the delay time.
Page 2 of 4