Download USER MANUAL FOR AREX DIGI SYSTEMS

3.5.3 Imbalance left to right per axle
After each brake test the AREX DIGI+ Brake Tester gives the imbalance between the maximum brake
force measured on the left and the maximum brake force measured on the right wheel of each axle. The
imbalance is expressed as a percentage of the higher of the two brake forces.
The imbalance is shown underlined on the print-out, when the maximum difference for that axle is
exceeded.
3.6 Sending the test data
You can send the test data of the vehicle with the remote control (option). For this function you need; a
serial cable and the DigiComm program on a PC.
When all the data of the vehicle have been assembled the data is sent automatically, or by pushing key
9, to the PC where the DigiComm program is running. The data is shown in the DigiComm program in
numerical and graphical layout and can be printed to a standard A4 printer.
After entry of the weight, the data which changes because of this is once again sent.
USER MANUAL AREX DIGI+ SYSTEMS
9