Download User Manual

9.4 Register Mapping
9.4.1 Holding registers
Registers from address 0 to 7 are compatible with the registers of the old instrument, in order to assure the backwards compatibility. The one described are the ones
of the KILO (T).
Registers from address 70 to 79 specific for FLASH.
Registers from address 8 to 69 and from 132 to 139 are reserved for future expansions.
Holding Registers
Addr.
0
1
2
Type
Integer Word
Integer Word
Integer Word
Description
CT Ratio
VT Ratio
AVG Integration Time
3
NOT USED
4
NOT USED
5
NOT USED
6
NOT USED
7
Integer Word
8
:
69
70
Digital
Watchdog
Range [Unit] or Bitmap
Return undefined valued, if read.
Written values will be ignored.
Return undefined valued, if read.
Written values will be ignored.
Return undefined valued, if read.
Written values will be ignored.
Return undefined valued, if read.
Written values will be ignored.
Outputs
0-65535 [min]
0 = Watchdog disabled
Return undefined valued, if read.
Don’t write in this area.
RESERVED
Bitmapped
Word
Words/Bytes
flags
swap
Swap bytes:
0 ≡ Standard;
1≡ Swapped
Swap words:
0 ≡ Standard;
1≡ Swapped
Swap doublewords: 0 ≡ Standard;
1≡ Swapped
Swap words in float values: 0 ≡ Standard;
Not Allocated
71
Integer Word
Tx delay time
Notes
1-9999 [A/A]
1-9999 [V/V]
1-60 [min]
(Must be set to 0)
0-100 [s/100]
Pag. 62 di 80
1≡ Swapped
Standard means Motorola like and
Swapped means Intel like.
The same bit combination must be written in
both low and high part of register.
In this manner the "byte swap" setting is
meaningless for this register.