Download USER MANUAL

Transcript
User Manual µSEM
Doc: MGA-µS1998-001
Version: 1.0
Page 6 of 6
Recharging of storage batteries
µSEM is fitted with an ‘intelligent’ recharge circuit for the storage batteries, which are first discharged and subsequently
recharged completely automatically. In this way the ‘memory’ effect, which reduces the working life of the storage
batteries, is avoided.
The charging of the storage batteries takes place only when the device is switched off. (When the device is switched on,
if the external power source is connected, a charge ‘maintenance’ procedure is activated).
To start the recharging of the storage batteries, you must:
• switch off the device
• then, connect to the Charge power supply socket on the side panel. The discharge phase of the storage batteries is
signaled when the L.Batt./Charge red led is continuously on. During recharging, the led is green and blinks. At the
end of recharging, the led is green and continuous
It is also possible to skip the discharge phase when recharging the storage batteries. This procedure should normally be
avoided, but it can be useful if the storage batteries need charging and there is not enough time to carry out the whole
discharge-recharge cycle.
To immediately activate recharging:
• switch off the device
• press the Green button and keep it pressed down
• connect to the Charge power supply socket on the side panel
• release the green button
After about a second recharging of the storage batteries will begin.
Indicator signals L.Batt./Charge
Indicator Status
Off
Blinking red
Continuous red
Blinking green
Continuous green
Meaning
Battery power source, batteries charged
Batteries discharged
Battery discharge phase in progress
Battery recharge phase in progress
Charging of batteries correctly completed
Mounting device
On the bottom of the device there is a threaded hole with photographic thread (1/4 “ W), for mounting on a stand.
Two hinges on the back of the device make it possible to hang the signal light unit on a wall.