Download hu

Installation
Signal bus cables to other SEW units - EtherCAT-based system bus
4
4.7
Signal bus cables to other SEW units - EtherCAT-based system bus
[1]
0
1
0
1
0
1
[2]
[3]
[4]
[5]
[1]
System bus connection cable
[4]
SEW stations with SEW EtherCAT interface
[2]
Output plug yellow
[5]
LAM switch
• Switch setting 0: All axis modules except the last one
• Switch setting 1: Last axis module in the system
[3]
Input plug green, RJ45
STOP
Important: The DIP switch LAM [5] must be set to "1" at the last axis module in a system. At all other axis modules, it must be set to "0".
The lengths of the pre-fabricated connection cables [1] are 0.75 m and 3 m.
STOP
Use only pre-fabricated cables from SEW-EURODRIVE (special assignment) for this
connection.
72
Operating Instructions – MOVIAXIS® MX Multi-Axis Servo Inverter